750 Matrix PRASAR UCS System Manual
These attributes must be programmed keeping in mind the application for which the communication port is used
(for instance, Programming through PC, generating SMDR Reports, etc.)
Changing the Communication Port attributes using Jeeves
• Login as System Engineer.
• Under Configuration, click Communication Ports to open the page.
• Set the desired values for USB1 to COM and USB2 to COM:
• Speed (Bps)
• Data Bits
•Parity
• Stop Bits
When the USB to COM converter is connected to the External USB Port, the same will be notified on this page.
Any one of the following USB to COM status will be displayed:
•Click Submit to save changes.
Status Description
Up
This will be displayed when the USB to COM
converter is connected,
the
port is available and functioning.
Down
This will be displayed when the USB to COM
converter is not
connected or not detected
.
Try re-plugging the device. The status will be updated accordingly.
Fail
This will be displayed when the USB to COM
converter is connected
but the internal registration fails
.
You may change any of the above parameter values or set the page to
default to re-initiate the registration process. The status will be updated
accordingly.
To Next Page
Loading...