758 Matrix PRASAR UCS System Manual
• Repeat the above steps to add new participants in the conference (max.64).
To include a party in a multiparty conference:
• After the Multiparty Conference has been initiated. Press the ‘Conference’ Key.
• The Multiparty Conference menu appears on the LCD.
• Select the option Include Party and dial the number.
• When you are in speech with the party, press the ‘Conference’ Key.
• Repeat the above steps to add new participants in the conference (max. 64).
To temporarily leave multiparty conference:
• While in Conference, press the ‘Conference’ Key.
• The Multiparty Conference menu appears on the LCD.
• Select the option ‘Leave Temporary’ and press the Enter Key.
OR
• Press the DSS key assigned to Temporary Leave Conference/Rejoin Conference.
To rejoin multiparty conference:
• Press the ‘Conference’ Key.
OR
• Press the DSS key assigned to ‘Temporary Leave’ Conference/Rejoin Conference.
To remove a party from multiparty conference:
• While in Conference, press the ‘Conference’ Key.
• The Multiparty Conference menu appears on the LCD.
• Select the option ‘Remove Party from Conf’
• The LCD displays the numbers of all the participants.
• Select the number of the participant you want to remove and press the Enter Key.
• The selected participant is disconnected.
To permanently leave from the multiparty conference:
• While in Conference, go ON-Hook.
To cancel multiparty conference:
• While in Conference, press the ‘Conference’ Key.
• The Multiparty Conference menu appears on the LCD.
• Select the option ‘Terminate Conference’ and press the Enter Key.
OR
• Press the DSS key assigned to Terminate Conference.
• All the participants will get an Error Tone and the system resource occupied by the conference will be
freed.
To Next Page
Loading...