780 Matrix PRASAR UCS System Manual
When DST Mode is set as 'Manual', you must set the start and the end time, that is, the time at which the
clock is to be advanced and the time at which the clock is to be delayed.
There are two ways to adjust DST manually:
1. The 'Day of Month' method, which specifies a day of the month DST will start or end. For example:
starting on the 2nd Sunday of March and ending on 1st Sunday of November.
2. The 'Date and Month' method, which specifies a date of the month that DST will start or end. For
example: starting on March 11 and ending on November 4.
DST is not applicable in certain regions/countries, like Asia and South America. In such cases, the DST
Mode is to be 'Disabled'.
How to configure
Adjusting DST using Jeeves
• Login as System Engineer.
• Under Configuration, click Date and Time.
• Click Daylight Saving Time (DST) to expand.
• Set the DST Mode to Manual or Scheduled as per your requirement.
Scheduled DST Adjustment
• If you have selected Scheduled as DST mode, in the Region list, select the name of the country/region
where your system is installed.
To Next Page
Loading...