Matrix PRASAR UCS System Manual 81
Connect the second DSS532 to the existing assembly
15. Plug one end of the RJ11 Cable into the OUT Port of the existing DSS532 (already connected with the
phone) and the other end into the IN Port of the second DSS532.
You can install a maximum of four DSS532 with a phone.
16. After you have connected the DSS532 with the phone, you can configure the DSS Keys. For instructions,
see “Programming DSS Console Keys”.
Connecting Extended SPARSH VP710 as Extended SIP Extension
You are recommended to complete the following steps before connecting the Matrix Extended SPARSH VP710 to
PRASAR UCS:
• Decide the location where you want to place Matrix Extended SPARSH VP710 within your LAN.
• Log in to Jeeves. For instructions, read the topic “Configuring Basic PRASAR UCS Settings”.
• You must configure the necessary parameters in PRASAR UCS so that Extended SPARSH VP710 can
register as a SIP Extension. For instructions, see “Configuring Matrix Extended SPARSH VP710”.
Now, follow the steps described below to install Extended SPARSH VP710.
To Next Page
Loading...