900 Matrix PRASAR UCS System Manual
2. Assigning a routing group (number) in the Floor Service feature in the Station Advanced Feature Template.
Prepare a different Station Advance Feature Template for each floor.
3. Applying the Station Advanced Feature Template (with the Floor service group programmed) to the
extension. This will assign the extensions to the routing group programmed in the Template.
If the Enterprise/Building has centralized floor service, you only need to create a single Routing Group with
service extensions, as required. This routing group number can be programmed on a common Station
Advanced Feature Template which will be applied to all extensions.
Floor Service parameters can be programmed using Jeeves and a Telephone.
Programming Floor Service using Jeeves
• Log in as System Engineer.
• Under Configuration, click Routing Group.
• You can create 96 Routing Groups with 32 members in each group.
• Select a Routing Group Number from 1 to 96.
• For each Group you must configure the following:
• Configure the Name you wish to assign to the Routing Group.
• Select the Rotation check box to enable rotation of calls in the routing group which has multiple
'member' extensions. When enabled, each fresh call will land on the extension which is next to the one
that received the last call. This ensures equal distribution of incoming calls to all the destinations within
the routing group. The option is not relevant if the routing group has only one member extension.
• If any member extension rejects an incoming call and the system again checks the routing group
sequence, you can allow or restrict placing the same call on this extension. Select the When member
To Next Page
Loading...