952 Matrix PRASAR UCS System Manual
• Authentication ID: Enter the ID for authentication. The Authentication ID entered here should
match with the Authentication ID configured in the LDAP server. You cannot keep this field blank.
The ID may be a string of maximum 40 characters. Default: Blank.
• Authentication Password: Enter the Password for authentication. The Authentication Password
entered here should match with the Authentication Password configured in the LDAP server. You
cannot keep this field blank. The Password may be a string of maximum 24 characters. Default:
Blank.
Authentication ID and Password can only be configured when Enable Authentication check box is
enabled. Contact your SE for more details.
• Base Distinguished Name: Enter location in the LDAP Server from where the search should begin. You
can also specify the subtree as the base entry. You cannot keep this field blank. Default: Blank.
• Name Attribute: You can define the Name attribute to be fetched from the LDAP server directory here.You
cannot keep this field blank. Default: Blank.
• Number Attribute: You can define the Number attribute to be fetched from the LDAP server directory
here. You can define only one attribute and hence the system will fetch only one number per contact from
the search results. You cannot keep this field blank. Default: Blank.
• Email Attribute: You can define the Email Attribute to be fetched from the LDAP server directory here.
This needs to be configured only if you need the Email-id of the required contacts.
• Search Filter: You can use the Search filter when specific entries from a particular Distinguished Name
are required. Enter the details after contacting you LDAP Server Administrator.
Synchronization
The Synchronization with the LDAP server will function only if the parameters mentioned under LDAP have been
configured correctly.
You can now proceed further with configuring the Synchronization parameters:
• Global Directory for LDAP: Select the Global directory in which the search results obtained from the
LDAP server should be stored. You can select either one or combination of — Global Directory 1, Global
Directory 2, Global Directory 3. By default, Global Directory 1 is selected.
• Synchronize Status: Displays the synchronization status (In Progress, Fail or Pass) of the system with
LDAP server.
• Last Synchronized on: Displays the date & time when the system last synchronized with LDAP server.
• Click on Sync Now button to manually synchronize the system with the LDAP Server.
• Test: You can test the parameters configured in the system for LDAP synchronization. To do so,
• click the Test button. A new window for Test is displayed.
• Select the desired attribute and enter the — Name, Number or Email-id.
• Click the Test button.
• If the connection has been successfully established then search results fetched from the LDAP server
will be displayed.
To Next Page
Loading...