Matrix PRASAR UCS - Page 981

972 Matrix PRASAR UCS System Manual
• The Automatic Number Translation table would look like this:
• When the Automatic Number Translation table is configured, the Extension user can simply dial the Trunk
Access code (0/5/61/62/63/64) and the destination number (0014125126508).
• The system matches the dialed number with the Dialed Number String of the ANT table, the number
matches with the entry ‘00’ stored in the table.
• The system dials the Add Prefix Number string 1602233 (number of the calling card server). It waits for the
calling card server to answer the call.
• When the call is matured, i.e. the calling card server has answered the call, the system dials the PIN
number 1132121234 and waits for the Pause Timer before dialing the destination.
Thus, the extension user directly dials the desired destination number and the system substitutes this number
by adding the Calling Card server number and PIN number and dials these numbers in two stages.
How to configure
Configuring Multi-Stage Dialing using Jeeves
To be able to use Multi-Stage Dialing, you must configure the following:
• Automatic Number Translation table on the trunk you want to use this feature. For instructions on
configuring ANT on SIP Trunk, see “Automatic Number Translation” and to assign the ANT Table number
see “Outgoing Trunk Bundle”.
• Configure the DTMF Out Dial on the SIP Trunk. Set the DTMF ON Time and the DTMF Inter Digit Pause
and Pause Timer to the required values.For instructions on configuring DTMF Out Dial on SIP Trunk, see,
“Configuring SIP Trunks”.
• If required you may configure the Call Proceeding Tone for Multi-stage Dialing as Network tone,
Pseudo Tone, or Silent. For instructions, see “System Parameters”.
Index Dialed Number String Strip Digits Add Prefix
1 00 00 1602233W1132121234P
2
3
4
5
6
:
32