3. SETTING UP THE SJ-210
No. 99MBB122A
3-19
■ Power supply from an AC adapter (when using an AC adapter)
IMPORTANT
• Do not connect the AC adapter to a power line which may cause electrical interference.
Although this instrument has reasonable protection against electrical interference,
supplying power from such a line may hamper correct measurement.
• When you have removed the rear cover of the display unit, take care and do not have
the AC adapter plug contact with the SPC or RS-232C connector. Instrument failure
results.
1 Set the built-in battery on/off switch to ON. For more information about the built-in
battery on/off switch, refer to “■ Power supply from a built-in battery (when using a
built-in battery)”.
Proceed to the next step once the battery switch is on.
2 Connect the AC adapter to the wall outlet.
3 Remove the connector cap from the rear cover, then insert the AC adapter plug into
the connector.
Connection of the AC adapter
4 Press the [POWER/DATA] key.
Connector cap
AC adapter plug
[POWER/DATA] key
To Next Page
Loading...
