1. Select Preferences entry from the File menu.
2. Select the MIDI page.
3. In the Sync section select Slave (Receive Clock) from the menu.
4. Select the Input button to see a list of connected devices.
5. Check the name of the device sending MIDI clock (the device you want MASCHINE to
sync with).
→ MASCHINE can now receive MIDI Clock from an external device
You must define at least one MIDI input device in the Devices section of the MIDI page to enable
MASCHINE to sync.
When Slave (Receive Clock) is selected, the Play button in the MASCHINE Header and the
PLAY button on your controller are deactivated.
If you want to configure MASCHINE to react to other MIDI messages than MIDI Clock, in particular
if you want to control MASCHINE notes and parameters via MIDI, please refer to section ↑12.2, Us-
ing MIDI Control and Host Automation, where this is described in detail.
3.7.3 Send MIDI Clock
If MASCHINE is running as a stand-alone application, it can also send a MIDI Clock signal to
any device that is capable of receiving MIDI Clock. This could be hardware such as a drum
machine, another groovebox, or even another software sequencer.
If you use MASCHINE as a plug-in, it cannot send any MIDI Clock signal. See section ↑3.5, Stand-
Alone and Plug-in Mode for more information on using MASCHINE as a plug-in.
To configure MASCHINE to receive MIDI Clock from an external device:
1. Select Preferences entry from the File menu.
2. Select the MIDI page.
3. In the Sync section select Master (Send Clock) from the menu.
Basic Concepts
Integrating MASCHINE into a MIDI Setup
MASCHINE MIKRO - Manual - 132
To Next Page
Loading...
Need help?
General
Weight and Dimensions
