5. Click the little field on its left to select a MIDI channel.
This is equivalent to the Channel parameter described above.
12.2.2 Triggering Scenes via MIDI
The MASCHINE hardware SCENE mode can be configured to send out MIDI (Notes/Program
Changes) which can be used to trigger scenes. When MASCHINE runs as a Plug-in this MIDI
data is sent to the host application. When MASCHINE runs as a stand-alone application this
MIDI data is send out to all activated MIDI output devices.
MIDI Scene Change program change messages can be used to record a Scene performance to
a host application, and all recorded Scene performances can be then be saved within your host
and sent back to MASCHINE for playback and trigger Scenes in the recorded order.
Sending MIDI Scene Change Messages
To enable or disable the MIDI Scene Change feature, do the following:
1. Click Edit > MIDI Change.
2. In the submenu that opens, select the source you want to use for changing the MIDI Pro-
gram Change messages. A list of connected controller names appear in the drop-down
menu, or you can select None to disable the feature.
3. Then from the drop-down menu select MIDI Note to trigger your Scenes via MIDI notes, or
Program Change to trigger your Scenes via MIDI Program Change messages.
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE MIKRO - Manual - 579
To Next Page
Loading...
Need help?
General
Weight and Dimensions
