9.2.5 Kick – Rasper
The Rasper kick is an acoustic bass drum emulation providing a unique and organic sound that
can be easily adapted into Drum’n’Bass or Dubstep productions. Its two crispness modes allow
for a wide range of bass drums.
The parameters described below are presented as they appear in the Control area (Arrange view).
The same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
↑13.4, The Plug-in Strip for more information on this.
Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to ↑9.2, The Kicks.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 38.00 to
62.00. The default value is 50.00. For more details see ↑9.1.5,
Pitch Range, Tuning, and MIDI Notes.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Punch Simultaneously adjusts the amount of the pitch envelope and the
amount of noise of the attack. Available values range from 0.0 to
100.0 % (default).
Impact Adjusts how hard the drum is hit. Available values range from
0.0 % (softest) to 100.0 % (hardest). The default value is 75.0 %.
CRISPNESS Section
Mode Selects from two different crispness modes: Select A (default) for a
tambourine-like sound, and select B for a snare-like sound.
Using the Drumsynths
The Kicks
MASCHINE MIKRO - Manual - 373
To Next Page
Loading...
Need help?
General
Weight and Dimensions
