12.1.2 Configuring the Main Output of Sounds and Groups
By default the outputs of all Sounds in a Group are sent to this Group, where they are mixed
together and processed by the Plug-ins loaded in the Group, if any. Similarly, by default the
outputs of all Groups are sent to the Master, where they are mixed together and processed by
the Plug-ins loaded in the Master, if any.
This default behavior can be customized to your liking: You can adjust the level and panoramic
position of the channel output, or send it to the Cue bus for pre-listening. Furthermore, you
could send individual Sounds or whole Groups to other pairs of outputs on your audio interface
in order to process them separately at a later stage. The output routing configuration is done
on the Audio page of the Output properties for Sounds and Groups.
We describe here the Audio page of the Output properties for Sounds and Groups only. The equiva-
lent page for the Master will be described in section ↑12.1.4, Configuring the Master and Cue Out-
puts of MASCHINE.
The Audio page of the Output properties (here for a Sound) in the software.
The AUDIO page of the Output properties (here for a Sound) on the controller.
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
MASCHINE MIKRO - Manual - 553
To Next Page
Loading...
Need help?
General
Weight and Dimensions
