7.2.2 Page 2: Pitch / Envelope
Sampler parameters – page 2 of 6: PITCH / GATE and AMPLITUDE ENVELOPE on the controller.
Sampler parameters – page 2 of 6: PITCH / GATE and AMPLITUDE ENVELOPE in the software.
Parameter Description
PITCH / GATE
Tune Defines the basic pitch of your Sample: turn the knob to the right for
a higher pitch and to the left for a lower pitch.
Start Determines the start point of the Sample. This parameter can also be
modulated by the Velocity control, see ↑7.2.5, Page 5: LFO.
Reverse If Reverse is activated, the Sample will be played backwards.
Type Selects from three different types of amplitude envelopes. See below
for more information.
AMPLITUDE ENVELOPE
The AMPLITUDE ENVELOPE section allows you to tailor your Sample in terms of its loudness
over time.
Working with Plug-ins
The Sampler Plug-in
MASCHINE MIKRO - Manual - 324
To Next Page
Loading...
