→ The selected Arrange Grid value is applied.
On your controller:
1. Press the GRID button to access the Grid page.
2. Press F2 to select ARNG (Arrange).
3. Press the left arrow to step through the menu to select VALUE.
4. Turn the Control encoder to select an Arrange Grid value.
→ The selected Arrange Grid value is applied.
To enable/disable the Arrange Grid
1. Press the right arrow to step through the menu to select ENABLE.
2. Turn the Control encoder to select ON or OFF.
→ The Arrange Grid is enabled or disabled.
16.7 Quick Grid
The Quick Grid setting allows you to quickly and conveniently set the most common Pattern
lengths using your controller.
Quick Grid is only accessible from your controller.
When the Quick Grid is used, the following rules apply:
â–ª The available Pattern lengths are as follows:1 bar, 2 bars, 4 bars, 8 bars, 12 bars, 16 bars,
etc. (+ 4 bars each time starting from 4 bars).
â–ª The Quick Grid is exclusively applied to Pattern Length. For all other features related to the
Grid (for example, adjusting the playback position or the Loop Range), the Arrange Grid is
used.
â–ª The Quick Grid setting is global and applies to all Patterns.
Working with the Arranger
Quick Grid
MASCHINE MIKRO - Manual - 812
To Next Page
Loading...
Need help?
General
Weight and Dimensions
