17.4.1 Opening the Slice Page
In the software, slicing a Sample is done in the Slice page of the Sample Editor.
► In the Sample Editor, click the Slice tab at the top to open the Slice page.
The Slice page looks as follows:
The Slice page in the software.
Opening the SLICE Page on Your Controller
► In Sampling mode, press NAV + pad 15 to access the SLICE page. You can also hold NAV
and turn the Control encoder.
The SLICE page looks as follows:
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 850
To Next Page
Loading...
