5. Press F3 (REMOVE).
→ The Section is removed from the arrangement. The next Sections shift ahead to fill the
gap.
Alternate Method
1. Press SHIFT + SCENE to enter Song view.
2. Press and hold SCENE to enter Section mode.
3. Press SHIFT + Left/Right Arrow to select the desired Section bank.
4. Press ERASE + the pad corresponding to the Section you want to remove.
→ The Section is removed from the arrangement. The next Sections shift ahead to fill the
gap.
If the desired Section bank is already selected (or if there is only one Section bank), this alternate
method can be simplified as follows: Press ERASE + SCENE + pad to remove the corresponding
Section!
16.3.10 Renaming Scenes
Sections are displayed in the software using the names of the Scene they reference. Sections
do not have separate names from the Scene they represent. On the controller, they are refer-
enced by their position, for example, #4.
To organize your song, you can rename Scenes and use custom names of your own. Naming is
only available from within the software, but any changes will also show up in both views of the
Arranger (Ideas view and Song view) and on your controller.
Renaming Scenes in the Song view
To rename a Scene in the Song view:
Working with the Arranger
Using Song View
MASCHINE MIKRO - Manual - 798
To Next Page
Loading...
Need help?
General
Weight and Dimensions
