Monitoring the Input Signal
The level meters in the middle of the display show you at any time the level of the selected
audio source. For example, this can come in handy to adjust the appropriate threshold in De-
tect mode. For this purpose, in Detect mode the level meters provide a little down-pointing ar-
row indicating the threshold level.
Monitoring the input signal.
Furthermore, if you have selected an external signal (EXT. STER. or EXT. MONO selected in
SOURCE), an additional MONITOR section is available by pressing NAV + Right Arrow button.
In this section, You can set MONITOR to ON in order to send the input signal to the Cue bus of
MASCHINE, allowing you to hear on a separate channel (e.g., your headphones) the audio
source that is about to be recorded.
For more information on how to use the Cue bus, please refer to section ↑13.2.6, Using the Cue
Bus.
17.2.3 Arming, Starting, and Stopping the Recording
The Start and Cancel buttons.
â–º Click Start to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE selector, see section ↑17.2.2, Selecting the Source and the Recording
Mode above):
Sampling and Sample Mapping
Recording Audio
MASCHINE MIKRO - Manual - 826
To Next Page
Loading...
Need help?
General
Weight and Dimensions
