4. Press Pad 1 to add the first Slice to the sample.
5. Press Pad 2 to add the second slice point.
6. Continue to press subsequent pads as they flash to add more slices.
→ When playback of the sample stops you may fine-tune the start and end points of your
slices by entering EDIT mode.
Press SHIFT + MUTE if you want to stop playback of a long sample.
Press SHIFT + Arrow buttons to access each bank of Slices.
17.4.3.2 Delete All Slices
The DELETE ALL option in SAMPLING EDIT mode is a quick and convenient way to delete all
Slices at once from a sample using your controller.
Use the DEL ALL option to delete all slices at once from a sample.
To delete all Slices from a sample:
1. Press the SAMPLING button to enter the Sampler.
2. Press NAV and turn the Control encoder to select SLICE.
3. Press F1 to select EDIT mode.
4. Press SHIFT + F3 to select DEL ALL to delete all slices.
→ All slices are deleted from the current sample.
Deleting All Slices after They Have Been Applied to the Pattern Editor
If you have committed your Slices using the APPLY option, you must return to Edit mode and
apply the DELETE ALL option to fully remove them from the Keyzone and Pattern.
To delete all Slices after they have been applied:
1. Press the SAMPLING button to enter the Sampler.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 857
To Next Page
Loading...
Need help?
General
Weight and Dimensions
