The RECORD page on the controller.
1. To select the parameters described in the following sections, press the Left/Right Arrow
buttons.
2. To adjust the selected parameter, turn the Control encoder (for continuous parameters,
press and turn the Control encoder to adjust the value in finer increments).
17.2.2 Selecting the Source and the Recording Mode
At the bottom of the Record page, the parameters in the INPUT section and the RECORDING
section allow you to select which source should be recorded and how the recording should be
made.
Adjusting the source and mode of the recording in the software.
Selecting the Source to Record
â–º Click the SOURCE selector on the left to select the type of source you want to record:
â–ª To record external audio signals connected to your audio interface, select Ext. Ster. (for
stereo signals) or Ext. Mono (for mono signals).
â–ª To record audio signals coming from MASCHINE itself, select Internal.
â–º Click the INPUT selector to choose between the available inputs:
▪ If SOURCE is set to Ext. Ster., you can select either of MASCHINE’s four external stereo
inputs In 1–4.
Sampling and Sample Mapping
Recording Audio
MASCHINE MIKRO - Manual - 818
To Next Page
Loading...
Need help?
General
Weight and Dimensions
