3. Press SHIFT + F3 (AUT LEN) to enable Auto Length.
→ Auto Length is enabled and the selected Section is automatically resized to fit the content
of the Patterns within the assigned Scene.
16.3.15 Looping
Activate a Loop to repeatedly play a section of the Arrangement. Once a loop is activated the
Sections within the range of the Loop play until the loop is deactivated. You can use the range
to repeatedly play a particular part of a song. This can be good for composing, practicing a part
before recording, recording multiple takes, etc. The loop range is permanently visible, (even
when it is deactivate) and the range of the loop can be altered at any time using the left and
right end points.
16.3.15.1 Setting the Loop Range in the Software
Set the start, end and position of the loop using the dedicated Loop range in the Timeline. The
value set in the Arrange Grid is used for Loop range increments and movement of the loop
range itself.
To adjust the Loop range using the software:
â–º Drag the left or right end of the Loop marker to make it longer.
→ The Loop range is elongated.
To move the Loop using the software:
Working with the Arranger
Using Song View
MASCHINE MIKRO - Manual - 804
To Next Page
Loading...
Need help?
General
Weight and Dimensions
