On the display of your controller, the Browser is organized as follows:
â–ª When the F1 button (FILTER) is selected, you can narrow your search by using the F3 but-
ton, the Left/Right Arrow buttons, and the Control encoder to select the file type, the con-
tent type (factory or user files), the product/bank/sub-bank, and the desired Type (and pos-
sibly Mode) tags.
â–ª When the F2 button (LIST) is selected, you see the corresponding search result list. Using
the Control encoder you can select and load the desired file.
The above steps are described in detail in the following sections. In addition, you will find on
your controller most of the browsing aids available in the software, as described in section
↑4.3, Additional Browsing Tools.
Make sure you tag all the files extensively that you want to use often, as this makes them much
easier to access using the controller.
4.2.2 Selecting or Loading a Product and Selecting a Bank from the Browser
The Product selector allows you to limit your search to a certain product category, a particular
product, or a specific bank of the product. You can also load a product along with its default
preset file directly from the Product selector (see below).
By default there is no particular selection in the Product selector; it reads All Instruments:
Browser
Searching and Loading Files from the Library
MASCHINE MIKRO - Manual - 142
To Next Page
Loading...
Need help?
General
Weight and Dimensions
