7.2.6 Page 6: Velocity / Modwheel
Sampler parameters – page 6 of 6: VELOCITY DESTINATION and MODWHEEL DESTINATION on the controller.
Sampler parameters – page 6 of 6: VELOCITY DESTINATION and MODWHEEL DESTINATION in the software.
VELOCITY DESTINATION
This section allows you to use the input velocity in order to modulate various parameters.
Parameter Modulation Destination
Start Start parameter of the PITCH / GATE section on the Pitch / Envelope
page (page 2). Positive values shift the Sample start position later in
time as you play harder, negative values shift it closer to the
beginning of the Sample as you play harder.
Tip: a typical example for this parameter is setting it so that the
initial attack transient of a snare drum is heard only at high velocity
values. This makes it sound “snappier” when you play hard, and
“muffled” or muted when you play softly.
Decay Decay parameter of the AMPLITUDE ENVELOPE section on the
Pitch / Envelope page (page 2).
Working with Plug-ins
The Sampler Plug-in
MASCHINE MIKRO - Manual - 332
To Next Page
Loading...
Need help?
General
Weight and Dimensions
