1. While holding NOTE REPEAT, hold any pad.
The Sound of the pad is repeatedly triggered at the rate shown at the bottom of the con-
troller’s display.
2. Press F1, F2 or F3 above the display to select another repetition rate.
→ This is a handy way to add live ornaments to your Pattern!
Of course you can also use Note Repeat to program your Pattern (e.g., recording a continuous hi-
hat).
Note Repeat mode seamlessly switches to Arp mode as soon as you switch your pads from Pad
Mode to Keyboard mode (see below): All current values (including the LOCK state) are retained.
Pads in Keyboard mode: Arp
If your pads are in Keyboard mode, pressing NOTE REPEAT switches your controller to Arp
mode:
In Arp mode you can customize the way the notes of the played chord will be arpeggiated by
adjusting following settings:
Playing on the Controller
Performance Features
MASCHINE MIKRO - Manual - 295
To Next Page
Loading...
