The Audio Plug-in with a bass recording in Loop mode.
Enabling and Disabling Audio per Pattern
When using Loop mode with the Audio plug-in, it is possible to enable and disable audio in the
current Pattern in the Pattern Editor. By default, when audio is recorded using the Audio plug-
in, or if it is tagged as a ‘Loop’ and loaded directly from the Browser, it will be enabled in the
Pattern and play back when you press Play.
To disable audio and temporarily remove it from the Pattern simply double-click its waveform.
By clicking the same area again the audio can be reactivated for the Pattern.
Using the Audio Plug-in
Using Loop Mode
MASCHINE MIKRO - Manual - 354
To Next Page
Loading...
