The parameters described below are presented as they appear in the Control area (Arrange view).
The same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
↑13.4, The Plug-in Strip for more information on this.
Element Description
MAIN Section
Engine Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to ↑9.2, The Kicks.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 36.00 to
60.00. The default value is 48.00. For more details see ↑9.1.5,
Pitch Range, Tuning, and MIDI Notes.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Snap Emulates the air movement caused by the beater before the drum is
hit. Therefore, it produces a snap in the waveform the length of
which can be controlled through this parameter. Available values
range from 0.0 to 100.0 % (default: 50.0 %).
Impact Adjusts how hard the drum is hit, measured as a percentage.
Available values range from 0.0 % (softest) to 100.0 % (hardest).
The default value is 75.0 %.
PUNCH Section
Mode Selects from two different punch modes: A (default) and B.
Decay Adjusts the duration of the punch, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Amount Adjusts the amount of punch, measured as a percentage. Available
values range from 0.0 to 100.0 % (default).
Advanced Page
For this engine the Advanced page does not contain any parameters.
Using the Drumsynths
The Kicks
MASCHINE MIKRO - Manual - 375
To Next Page
Loading...
Need help?
General
Weight and Dimensions
