Element Description
Mod. Amt. Adjusts the amount of envelope applied to the filter cutoff (range:
0.0% – 100%). To increase the amount of modulation applied to
the Cutoff, turn the Mod. Amt. knob clockwise by clicking and
dragging upwards.
Decay Adjusts the rate at which the sound fades to silence (range: 0.0% –
100%). To increase the decay amount, turn the Decay knob
clockwise by clicking and dragging upwards.
Tone Section
Drive Adjusts the amount of drive (range: -100% – 100%); -100%
increases the input level for the filter, driving the signal internally
into saturation, and 100% controls the drive level of the distortion
at the end of the signal chain. To adjust the amount of drive, turn
the Drive knob by clicking and dragging upwards or downwards.
Note Section
Glide Time Adjusts the time it takes to glide from one pitch to the next (range:
10 ms – 1000 ms). To adjust the amount of glide time, turn the
Glide Time knob by clicking and dragging upwards or downwards.
Advanced Page
For this module the Advanced page contains just one parameter.
Element Description
Note Section
Glide Globally enables the glide parameter. Once set to on, the note will
continuously play in a monophonic manner.
Using the Bass Synth
Bass Synth – General Handling
MASCHINE MIKRO - Manual - 445
To Next Page
Loading...
Need help?
General
Weight and Dimensions
