3. Use the Left Arrow button under the display to select the VALUE parameter at the bottom
of the display:
4. Select a step size by turning the Control encoder.
Adjusting the Nudge Grid
To change the Nudge Grid resolution:
1. Hold GRID to enter Grid mode.
2. Press F3 (STEP) to access the Step and Nudge Grid settings.
3. Use the Right Arrow button under the display to select the NUDGE parameter at the bot-
tom of the display:
4. Turn the Control encoder to select the desired Nudge Grid resolution.
→ The new Nudge Grid resolution is directly in use — provided that the Step Grid is enabled
(see above).
Working with Patterns
Pattern Basics
MASCHINE MIKRO - Manual - 465
To Next Page
Need help?
General
Weight and Dimensions
