Controls Description
AUDIO Section
Output Selects where you want to send the master output of your
MASCHINE Project. Available options are the 16 external stereo
outputs Ext. 1–16.
Level Adjusts the overall volume level of the master output. This control
is the same as the Master Volume slider in the Header, at the top
right corner of MASCHINE’s window.
Pan Defines the panoramic position of the master output in the stereo
field.
CUE Section
Output Selects where you want to send the Cue bus of your MASCHINE
Project. Available options are the 16 external stereo outputs Ext. 1–
16. By selecting a different output from the one used for the main
stereo output, you can effectively pre-listen on this additional
output (e.g., on your headphones) any channel(s) currently sent to
the Cue bus. To send a channel to the Cue bus, enable the Cue
switch in the Audio page of its Output properties (see section
↑12.1.2, Configuring the Main Output of Sounds and Groups).
Level Adjusts the level of the Cue output.
Pan Defines the panoramic position of the Cue output in the stereo
field.
If MASCHINE is running as a plug-in, the external stereo outputs Ext. 1–16 available in the Output
selector of the MAIN and CUE sections will correspond to virtual outputs in your host.
Configuring the Master and Cue Outputs in Mix View
You can also easily configure the Master and Cue outputs of MASCHINE in the Mixer. Both
share the same channel strip at the far right of the Mixer.
To display the Master/Cue channel strip, do the following:
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
MASCHINE MIKRO - Manual - 563
To Next Page
Loading...
Need help?
General
Weight and Dimensions
