3. Click Learn in the Assignment field of a parameter to enter Learn mode for that parame-
ter.
The Assignment field shows a blinking Learning.
4. Move the desired control element (knob, button, etc.) on your MIDI controller.
→ The Assignment field automatically displays the MIDI message type received (CC number,
PC for Program Change, or PW for Pitchbend). The parameter is ready to be controlled via
MIDI.
Note that the assignments you create will receive MIDI messages on all channels of all enabled
MIDI ports.
For the Learn mode and the resulting MIDI control to work, MIDI must be correctly configured in
MASCHINE. If MASCHINE is running as stand-alone application this is done in the MIDI page of
the Preferences panel — for more details please refer to section ↑3.6.3, Preferences – MIDI Page.
If MASCHINE is running as a plug-in in a host application the MIDI configuration is done in the
host — see section ↑3.5, Stand-Alone and Plug-in Mode.
If there is already a MIDI assignment for the parameter, the new MIDI assignment will replace
the previous one. If you change your mind and don’t want to assign any new MIDI control,
while Learn is blinking click the Assignment field again or press [Esc] on your computer key-
board.
You cannot assign the same MIDI control to more than one parameter in MASCHINE: If a MIDI con-
trol is already assigned to a parameter, when you assign it to another parameter its first assignment
is automatically deleted.
If you want to simply remove a MIDI assignment without recording a new one, do the following:
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE MIKRO - Manual - 587
To Next Page
Loading...
Need help?
General
Weight and Dimensions
