Control Description
Channel Selects the MIDI channel on which the Sound will send MIDI data.
By default Sound slot 1 will send MIDI data on channel 1, Sound
slot 2 on channel 2, etc.
Transpose Applies an offset to the MIDI note numbers before the notes are
sent. Values range from -48 (downward transposition by 48
semitones, i.e. four octaves) to +48 (upward transposition by 48
semitones, i.e. four octaves). The default value is 0.
Configuring MIDI Output for Sounds in Mix View
You can also easily configure the MIDI output of your Sounds in MASCHINE’s Mixer:
1. Click the Mix View button on the left of the Arranger to switch from Arrange view to Mix
view:
2. Open the extended view of the Mixer by clicking the down-pointing arrow on the left of the
Mixer:
3. Check that the IO button is active on the left of the Mixer — if not, click it to enable it
and display the input/output settings of each channel strip.
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE MIKRO - Manual - 591
To Next Page
Loading...
