If the desired Sound does not appear in the Sound List, use the scroll bar at the right end of the
Pattern Editor or turn your mouse wheel while hovering the Pattern Editor to display any hidden
Sounds.
You can also select multiple Sounds at once to apply changes to all of them. See section ↑5.1.3,
Selecting Multiple Sounds or Groups for more information.
Focusing on a Group using the Hardware
1. If necessary, press GROUP + the Left or Right Arrow button below the display to switch to
the Group bank containing that Group.
2. Press GROUP + the pad 9–16 of the desired Group.
→ The corresponding Group is now in focus.
Once the Group is focused you can use F1–F3 above the display to quickly switch between the
Master, the focused Group and the last focused Sound in that Group! See section ↑3.3.5,
Switching Between the Master, Group, and Sound Level for more information.
You can also select multiple Groups at once to apply changes to all of them. See section ↑5.1.3,
Selecting Multiple Sounds or Groups for more information.
Setting the Focus on a Sound using the Hardware
1. If you want to set the focus on a Sound located in another Group, first select its Group as
described above.
2. Hold SELECT.
3. While holding SELECT, press F1 (QUIET) to enter Sound selection.
4. While holding SELECT, press the pad of the desired Sound.
→ The selected Sound is now in focus.
If the pads on your controller are in Pad Mode, simply press the pad of the desired Sound to set the
focus on that Sound!
Basic Concepts
Common Operations
MASCHINE MIKRO - Manual - 82