Manually Adjusting Slices Using Your Controller
Your controller provides a dedicated Slice Edit mode that allows you to select and fine-tune
each particular Slice.
â–º On the SLICE page of the Sampling mode, press F1 (EDIT) to enter/leave Slice Edit
mode.
→ When Slice Edit mode is active, F1 is fully lit and the EDIT label underneath is highlight-
ed.
The Edit mode in the SLICE page.
1. To select the parameters described below, press the Left/Right Arrow buttons.
2. To adjust the selected parameter, turn the Control encoder (for continuous parameters,
press and turn the Control encoder to adjust the value in finer increments).
In Edit mode following parameters and commands are available:
Parameter
Description
SELECTION section
SLICE Selects the Slice to edit. The display will show you which Slice is
currently selected. You can also use the pads to select Slices starting
from pad 1.
START Adjusts the start point of the selected Slice. If the start point of the
Slice and the end point of the previous Slice are still joined, moving
the start point of the Slice simultaneously moves the end point of the
previous Slice, so that both Slices stay joined.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 862