Editing Your Zones on the Controller
At the bottom of the display, the Zone settings allow you to adjust how each Zone should be
played back.
The Zone settings on the controller.
The various parameters always display the values for the focused Zone.
The parameters available in the Zone settings are spread over five pages. To access these pa-
rameters do the following:
1. If it’s not done already, press SAMPLING to enter Sampling mode and press NAV +
pad 16 to select the ZONE page. You can also hold NAV and turn the Control encoder.
2. Press NAV + Left/Right Arrow button to access the desired page of parameters.
While you hold NAV, you see the name of the current page at the bottom of the display:
3. Press the Left/Right Arrow buttons to select a particular parameter on the selected page.
4. To adjust the selected parameter, turn the Control encoder. For continuous parameters,
press and turn the Control encoder to adjust the value in finer increments.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE page allow you to adjust the portion of Sample that will
be played back when the Zone is triggered.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE MIKRO - Manual - 887
To Next Page
Loading...
