Hardware
356
6. VD 0 is created in DG 0 as shown in the screen below.
7. After making sure that the VD is created correctly, select [Accept] at the lower right of the
screen and press Enter.
8. The confirmation message "Save this Configuration?" appears. Select "Yes" and press
Enter to save the configuration.
9. The confirmation message "All data on the new Virtual Disks will be lost. Want to
Initialize?" appears. Normally, select "Yes" and press Enter.
10. "Virtual Disks" operation screen is displayed. If no other operation is required, select
[Home] at the lower left of the screen and press Enter.
11. The WebBIOS Home Menu is displayed. Virtual Disk you have created is displayed in the
lower right frame of the screen.
To Next Page
Loading...
