532
Execute the command such as below when updating the BIOS.
-> load -source tftp://192.168.1.1/0001A052_R828.rom -oemnecfiletype bios
Execute the command such as below when restoring the SG information.
-> load -source tftp://192.168.1.1/bmcsg1.zip -oemnecfiletype sg partition1
・ reset
The format of reset command is shown below.
reset [<options>] [<target>]
This command reboots(power cycle) of the partition(server). Add “-f” option if it is needed to be
powered off and on compulsory.
Below is the example.
-> reset partition1
IMPORTANT:
•After updating the BIOS, the new BIOS is started up at the next
DC
ement firmware is not necessar
.
IMPORTANT:
•Restoring SG information is executed for each partition
(server).
•The management firmware is automatically reset and the new
SG information is available after restoring the SG information.
HINT:
•SG,System Genaration, means the configuration settings for
the system.
IMPORTANT:
•There is a risk to break the OS disk if the power is off and on
compulsory during OS is operationg.
HINT:
•The power cycle means the behavior that the power is ON
automatically after the power OFF. Reboot means the behavior
that the power is ON after the power OFF.
To Next Page
Loading...
