138
31.5. Control start procedure
To star
t testing:
• An operator needs to be logged on with the authorization access level high
enough to perform testing.
Caution:
The Logging on procedure is described in ch. 11. The procedure
of outlining the authorization level is described in ch. 19 of this manual.
• Select a product to be tested with correctly determined data for the control
process,
• Enter to scale memory general parameters on control mode (in
accordance with ch. 31.2 and 31.3 of this manual),
• Remove load from the weighing pan,
• Press function hot-key (control start) located in the bottom bar
of the settings window, which opens an information window on entered
data:
where:
Abort control start
Control start
To Next Page
Loading...
