31
• After making changes press key, then a new message is displayed:
<Restart to apply the changes>,
• Go back to weighing and restart the device.
15.3. TCP protocol setting
TCP (Transmission Control Protocol) is a protocol for communication
between two computers. It operates in mode customer-server. Server awaits
on connection initiation on a specified port while customer initiates connection
to the server. Scale software allows setting the port for the „Tcp” protocol.
Procedure:
• Enter < Communication> parameter group as described in chapter 16
of this manual,
• Select: „
Tcp / Port” then you will see window <Port> with the
screen keyboard,
• Enter the required number and press
.
Caution:
The number of TCP port in RADWAG instruments is set to default value: 4001.
15.4. Wi-Fi
15.4.1. Wi-Fi network status
In order to view selected network parameters click <Network Status> field.
Displayed window provides the following parameters:
Name Value Description
Network - Network name
Network status Connected
Network status with values: connected,
disconnected
RSSI
- dbm
- %
Signal strength
Forget the network - Disconnection from a selected network
To Next Page
Loading...
