46
16.5.2. Procedure of attributing the card number to an operator
To use
a transponder card to log on an operator the card needs to be ascribed
to the operator in the database of operators.
Procedure:
• Connect the transponder card reader to the required communication
port (RS 232 (1) or RS 232 (2)),
• Choose a communication port for the reader (see ch. 16.4.1 in this
manual),
• In submenu <
Communication> set the baud rate to the same
as in the reader (default 9600b/s),
• Enter the database of operators and edit the selected operator going
to the field <
Card Number>,
• After entering the field <
Card Number> you will see the editing
field <Card Number> with the screen keyboard,
• Having approached the card to the reader the program automatically
displays in editing field <Card Number> the number of read card,
• Confirm the number by pressing
and return to weighing.
16.6. Additional display
16.6.1. Additional display port
Procedure:
• Enter parameters group < Devices> according to ch. 16 of this
manual, select „
Additional display / Port” and then choose an
appropriate option from the list.
Communication with additional displays can be performed via following
ports:
• RS232 (1),
• RS232 (2),
• Tcp.
To Next Page
Loading...
