28
14.3. Autozero
The auto
zero function has been implemented in order to assure precise
indications. This function controls and corrects „0” indication.
While the function is active it compares the results continuously with constant
frequency. If two sequential results differ less than the declared value of
autozero range, so the scale will be automatically zeroed and the pictograms
and will be displayed.
If AUTOZERO is disabled zero is not corrected automatically. However, in
particular cases, this function can disrupt the measurement process e.g.
slow pouring of liquid or powder on the weighing pan. In this case, it is
advisable to disable the autozero function.
Procedure:
• Enter < Weighing> according to ch. 14 of this manual, select
<
Autozero> and then set an appropriate value.
Accessible settings:
- Autozero off
- Autozero on
14.4. Minimum weight for different functions (LO)
Paramete
r <LO THRESHOLD> is associated with automatic weighing.
Next weighing will not be saved until the indication goes under the
THRESHOLD LO (net).
Procedure:
• After entering < Threshold Lo> according to ch. 14 of this manual
a keyboard is displayed,
• Inscribe LO and confirm by pressing
.
To Next Page
Loading...
Need help?
General
