170
Averaging time
Declaration of process duration in seconds (from
1s to 90s) – measurements carried out in set time
interval are used to calculate mean value, which is
the result of the measurement.
Automatic mode
Operation mode, in which the scale automatically
begins the following measuring process, if the load
placed on scale’s weighing platform exceeds value
of mass set in LO threshold.
33.3. Carrying out animals weighing procedure
• Enter the working mode < Animal weighing> according to ch.
33.1 of this user manual,
• Should the tested animal be weighed in a container, load the container
of scale’s weighing platform and tare its mass,
• On placing the tested animal on the scale’s weighing platform (in the
tarred container), press
key (Process start), which displays a message
box indicating course of the process,
• The message box contains data on:
- Progress bar indicated in %,
- Value of averaging time interval, set in local parameters,
-
key enabling aborting the process,
• On completing the measuring process, the value of measured result
is locked in the message box,
• Confirm completing the process by pressing
key.
34. WORKING MODE – VEHICLE SCALE
Working mode < Vehicle Scale> enables weighing trucks, determining
mass of loads based on weighments carried out on entering and exiting a
weighbridge.
34.1. Working mode activating procedure
• When in the main software window press pictogram located in the top
bar of the display which opens a submenu <Working modes> containing
list of available working modes,
To Next Page
Loading...
Need help?
General
