25
13.4. Inscribing tare
It is possible to inscribe a tare value.
Procedure:
• While in any work mode press , then the screen keyboard
is displayed,
• Inscribe tare and press
,
• The program returns to weighing and the and the display shows
the entered value with the „–” sign provided there was zero before
on the display.
13.5. Weighing for dual range scales
Switching between the I range and the II range happens automatically
(exceeding Max of the I range).
Weighment in the second range is signalled by a pictogram in the top left
corner of the display
. Then weighment is done with the accuracy
of the II range to the moment of returning to zero (autozero range
)
where the scale switches back to the I range.
Switching between the II range and I range is automatic both in the
switching point the autozero zone. While in AUTOZERO
– pictogram
appears. Then pictogram
is off and a scale returns to weighing in the
I range.
13.6. Toggling between weighing units
Operators ca
n change the weight unit in two ways:
• Pressing the unit symbol on the screen,
• Pressing formerly defined button <
Change unit>.
To Next Page
Loading...
Need help?
General
