34
The scale can communicate with a computer via following ports:
• RS232 (1),
• RS232 (2),
• Tcp.
16.1.2. Computer address
Procedur
e:
• Enter < Devices> parameter group as described in chapter 16 of this
manual,
• Choose „
Computer / Address” then the window <Address>
with the screen keyboard appears,
• Enter the required address and confirm it by pressing
.
16.1.3. Continuous transmission
Users ca
n enable continuous transmission from the scale to a computer.
Setting parameter <
Continuous transmission> starts subsequent
sending data from <
Weighing Printout Template> set in submenu:
„Setup /
Devices / Computer / Weighing Printout Template”.
Procedure:
• Enter parameters’ group < Devices> according to ch. 16 of this
manual,
• Choose „
Computer / Continuous transmission” and then set an
appropriate value.
Accessible settings:
- Continuous transmission off
- Continuous transmission on
To Next Page
Loading...
Need help?
General
