149
- Tare of the packaging
Status
- Control status (in accordance with ch. 31.6)
Put Empty 1/10
- Commands on control process
(1/3)
Value of the measuring lot
-
Data on a control process in progress (in
accordance with ch. 31.6 of this manual)
-
Change of the workspace: numerical data / chart
(in accordance with ch. 31.6 of this manual)
- Control completion
After the test has been completed the test is summarized (see ch. 31.8)
and the results are automatically saved in the database.
Caution:
A pattern and example of the report from estimating average tare are described
in ch. 31.14 of this manual.
31.10. Performing destructive testing in modes Empty-Full and Full-
Empty
“Destructive” control process complying with the regulation, and independently
on the batch size that exceeds 100 pcs., the size of a sample accepted by the
software for control process is 20 pcs. Other control criteria are accepted as
specified in the regulation.
After selecting from a list a product with set options for the destructive control
with determined measuring “lot”, and starting the control process, the software
will display messages facilitating the control process (as in the case of control
process described above).
Depending on the set control mode, the scale orders the following sequence of
weighing products: “empty-full” or “full-empty”.
Caution:
Remember to maintain the order for weighing products with packages and
empty packages. It is important to the software that carries out mass
calculations of products placed in a specific packaging.
To Next Page
Loading...
