250
In order to get back to a previous step of a process one must:
• Press
button of an edit window or information window, press
button of database data chart to see the following window:
• Press <
List of steps> button to see the list of carried out steps,
• Select a given position (step) out of the list and wait, the program will
automatically get back to a chosen step.
40. COMMUNICATION PROTOCOL
40.1. General information
A. Scales-indicator serial communication protocol serves for communication
between RADWAG scales and peripheral device, it uses RS-232C and
Ethernet interface;
B. It consists of commands sent from an external device to the scale and a
responses from a scale.
C. Responses are sent every time after receiving a command (reaction for
any command).
D. Using commands allows users to receive some information about the
state of scale and/or influence the operation e.g.: Requesting weighing
results, display control.
Caution:
Go to submenu: „
Devices / Computer / Port” to declare
communication port (see point 16.1.1 of this manual).
To Next Page
Loading...
