152
-
Change of the workspace: numerical data / chart
(in accordance with ch. 31.6 of this manual)
- Abort of control
After the test has been completed the test is summarized (see ch. 30.8)
and the results are automatically saved in the database.
Caution:
A pattern and example of the report from estimating average tare are described
in ch. 31.14 of this manual.
31.11.1. Abort of control - procedure
User may ab
ort a control that is being carried out with internal criteria.
It may be done by pressing function key
(abort control) in any
chosen moment. This key is located in the bottom part of a process window.
When the key is pressed the following message is displayed.
Pressing
key means getting back to the control in progress. Pressing
key means abort of the control. Abort of control results in getting back to
PGC mode setting window.
A report on control will be saved to <
Controls> database, report’s status -
<Terminated>.
To Next Page
Loading...
