89
Accessible options:
Manual every stable - Manual printout of each stable weighing result for mass
measurement over -LO- threshold
Manual first stable - Manual printout of the first stable weighing result for mass
measurement over -LO- threshold
Automatic first stable - Automatic printout of the first stable weighing result for mass
measurement over -LO- threshold
Automatic last stable - Automatic printout of the last stable weighing result for mass
measurement below -LO- threshold
Semi-automatic every
stable
- Manual printout of each weighing result for mass
measurement over -LO- threshold – awaiting for a stable result
Semi-automatic first
stable
- Manual printout of the first weighing for mass measurement
over -LO- threshold – awaiting for a stable result
25.3. Down-weighing
Software all
ows to weigh in the “down-weighing” mode. It consist in putting the
load on the pan and taking off/removing portions of it with concurrent saving
weighments equal to the portions taken off the pan.
Procedure:
• Enter parameters group < Working Modes> according
to ch. 25 of this manual,
• Enter the required working mode and choose <
Down-weighing>
and then set the required option.
Accessible options:
- Traditional weighing
- Down-weighing mode