63
None
Output disabled
Stabile
Stable weighing result over LO threshold value
MIN stable
Stable weighing result below the MIN threshold
MIN non-stable
Non-stable weighing result below the MIN threshold
OK stable
Stable weighing result between MIN and MAX
thresholds
OK non-stable
Non-stable weighing result between MIN and MAX
thresholds
MAX stable
Stable weighing result over the MAX threshold
MAX non-stable
Non-stable weighing result over the MAX threshold
Zero
Stable weighing result zero net
Confirmation of
cycle completion *
Signal that confirms that a cycle of dosing has been
completed (the defined amount)
Zero
Zero weighing result („zero” indication)
! OK unstable
Unstable weighing result out of OK threshold
! OK stable
Stable weighing result within OK threshold
Measurement
saved
Signal for measurement record confirmation -
OUT programmed to be active for 500 [ms]
Tarring completed
Signal for tarring operation confirmation -
OUT programmed to be active for 500 [ms]
Zeroing completed
Signal for zeroing operation confirmation -
OUT programmed to be active for 500 [ms]
Error
Error message displayed
PGC – pending
weighing process
Signal for awaiting for weighing performed within
PGC control process
PGC – pending
control
Signal for awaiting for PGC control
*) Not applicable to „Standard” software.
• Choose the required function from the list and return to weighing saving
the changes according to ch. 12.2 of this manual.
Caution:
By default all outputs have no function attributed – setting <None>.
To Next Page
Loading...
Need help?
General
