8
40.4.9. Send the result immediately in current unit.............................................................................. 256
40.4.10. Switch on continuous transmission in basic unit.................................................................... 257
40.4.11. Switch off continuous transmission in basic unit.................................................................... 257
40.4.12. Switch on continuous transmission in current unit................................................................. 257
40.4.13. Switch off continuous transmission in current unit................................................................. 258
40.4.14. Set lower threshold ............................................................................................................... 258
40.4.15. Set upper threshold............................................................................................................... 258
40.4.16. Read lower threshold............................................................................................................ 258
40.4.17. Read upper threshold............................................................................................................ 259
40.4.18. Simulation of pressing ENTER/PRINT key............................................................................ 259
40.4.19. Change platform ................................................................................................................... 259
40.4.20. Give balance serial number...................................................................................................260
40.4.21. Set mass value of a single item............................................................................................. 260
40.4.22. Set reference mass value ..................................................................................................... 260
40.4.23. Activate sound signal............................................................................................................ 261
40.4.24. Give available working modes...............................................................................................261
40.4.25. Set working mode ................................................................................................................. 262
40.4.26. Give current working mode ................................................................................................... 263
40.4.27. Send all implemented commands ......................................................................................... 263
40.5. Manual printouts / automatic printouts ............................................................................................... 264
41. MODBUS RTU COMMUNICATION PROTOCOL.................................................................................... 264
41.1. Memory map...................................................................................................................................... 266
41.1.1. Output address........................................................................................................................ 266
41.1.2. Input address .......................................................................................................................... 267
41.2. Description of variables...................................................................................................................... 267
41.2.1. Output variables...................................................................................................................... 267
41.2.2. Input variables......................................................................................................................... 271
42. COOPERATION WITH PERIPHERAL DEVICES .................................................................................... 274
43. DIAGRAMS OF CONNECTION CABLES ............................................................................................... 275
44. TECHNICAL PARAMETERS................................................................................................................... 277
45. ERROR MESSAGES............................................................................................................................... 278
46. ADDITIONAL EQUIPMENT..................................................................................................................... 279
47. APPENDIX 01 – Variables for printouts ................................................................................................ 279
47.1. Inventory of variables......................................................................................................................... 279
47.2. Formatting variables .......................................................................................................................... 288
47.3. Mathematical function........................................................................................................................ 290
48. APPENDIX 02 – Functions of programmable buttons ......................................................................... 292
49. APPENDIX 03 – Label template............................................................................................................. 299
49.1. Designing a label from the indicator level........................................................................................... 299
49.2. Designing a label on a computer........................................................................................................ 300
49.3. Saving label templates in the scale.................................................................................................... 304
49.4. Attributing a label to a product ...........................................................................................................304
49.5. Attributing a label to a customer......................................................................................................... 305
49.6. Printing labels .................................................................................................................................... 305
50. APPENDIX 04 - CITIZEN printer setting ................................................................................................ 305
51. APPENDIX 05 - ZEBRA printer setting.................................................................................................. 306
52. APPENDIX 06 - Communication with barcode scanners..................................................................... 306
53. APPENDIX 07 – Computer Program „PGC Viewer”............................................................................. 307
54. APPENDIX 08 – Cooperation with HRP Weighing Platform ................................................................ 309
54.1. External ambient conditions............................................................................................................... 309
54.2. LO Threshold for automatic functions ................................................................................................ 310
54.3. Automatic adjustment ........................................................................................................................ 310
54.4. Internal adjustment ............................................................................................................................ 312
54.5. Automatic adjustment time-triggered.................................................................................................. 313
To Next Page
Loading...
Need help?
General
