93
Procedure:
• Enter < Working modes> parameter group as described in chapter
25 of this manual,
• Enter the required working mode and choose: „
Labelling mode /
C label automatic triggering / Mode” and then set the required
option:
None
- Cumulative label printout is initiated by pressing
or
*
,
Mass
- Cumulative label printout is initiated by exceeding the
value set in parameter <
Threshold>. The value
is treated as the total from single weighments,
Number
- Cumulative label printout is initiated by exceeding the
value set in parameter <
Threshold>. The value
is treated as the number of single weighment.
*) Manual printing of cumulative labels can be done in two ways
depending on the button used:
Printing followed by zeroing label counter or the total mass
Printing without zeroing label counter or the total mass
By default setting button is accessible in the bottom part of the display
but activating the button
can be done in submenu: „ /
Display /
Actions” (see ch. 17.2 of this manual).
For automatic printout of cumulative labels counters and total mass
variables are always zeroed.
• Confirm the changes by pressing
and go to parameter
<
Threshold> then <Threshold> window appears with the screen
keyboard,
To Next Page
Loading...
Need help?
General
