R&S FSW Series - Page 1296

Remote Commands
R&S
®
FSW
1296User Manual 1173.9411.02 ─ 43
Useful commands for configuring remote control described elsewhere:
●
SYSTem:LANGuage on page 1332
Remote commands exclusive to configuring a network and remote control
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess............................................................. 1296
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator........................................................ 1296
SYSTem:DISPlay:LOCK............................................................................................... 1297
SYSTem:DISPlay:UPDate.............................................................................................1297
SYSTem:ERRor:DISPlay.............................................................................................. 1297
SYSTem:IDENtify:FACTory............................................................................................1297
SYSTem:IDENtify[:STRing]........................................................................................... 1298
SYSTem:KLOCk.......................................................................................................... 1298
SYSTem:LXI:INFO....................................................................................................... 1298
SYSTem:LXI:LANReset................................................................................................ 1298
SYSTem:LXI:MDEScription........................................................................................... 1299
SYSTem:LXI:PASSword................................................................................................1299
SYSTem:REVision:FACTory.......................................................................................... 1299
SYSTem:SHIMmediate ONCE.......................................................................................1299
SYSTem:SHIMmediate:STATe.......................................................................................1300
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
This command sets the GPIB address of the R&S FSW.
Parameters:
<Address> Range: 0 to 30
*RST: (no influence on this parameter, factory default 20)
Example:
SYST:COMM:GPIB:ADDR 18
Manual operation: See "GPIB Address" on page 787
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator <Terminator>
This command selects the GPIB receive terminator.
Output of binary data from the instrument to the control computer does not require
such a terminator change.
Parameters:
<Terminator> LFEOI | EOI
LFEOI
According to the standard, the terminator in ASCII is <LF>
and/or <EOI>.
EOI
For binary data transfers (e.g. trace data) from the control com-
puter to the instrument, the binary code used for <LF> might be
included in the binary data block, and therefore should not be
interpreted as a terminator in this particular case. This can be
avoided by using only the receive terminator EOI.
*RST: LFEOI
Configuring the R&S FSW